Juniper Mist
Juniper Mist wireless engineering
Mist provides rich client telemetry and service-level metrics. NetRobin works with Mist environments where those metrics point to a problem that still needs RF engineering to resolve — coverage, capacity, interference, or client behavior that telemetry can describe but not correct.
What the architecture looks like
- Mist APs managed through the Mist cloud with Marvis analytics
- Service Level Expectations: coverage, capacity, roaming, throughput, and successful connects
- RRM behavior and RF templates applied per site
- Client telemetry and per-client event timelines
- 6 GHz capable hardware and phased 6 GHz introduction
Where NetRobin typically helps
- Translating SLE failures into a measurable root cause and a concrete remediation plan
- Independent survey measurement to verify coverage and capacity assumptions
- Interference investigations where SLE shows degradation without an obvious Wi-Fi cause
- Design review and validation for new sites, refreshes, and 6 GHz rollouts
- Roaming investigations across mixed client fleets and real-time applications
What we review and measure
- SLE breakdowns and the underlying client event data
- RF template and per-site radio configuration
- Independent passive/active survey results at client height
- Over-the-air packet captures for roaming and authentication analysis
- Spectrum captures where non-Wi-Fi energy is a candidate cause
Common questions
If Mist reports a coverage SLE failure, do we need a survey?
Usually yes, at least a targeted one. SLE tells you that clients in an area are below expectation; a survey tells you why — AP placement, antenna choice, attenuation, or a channel plan that cannot be fixed from the dashboard.